1 Use the wide-tooth comb to comb out all the hair. Make sure that there are no tangles. The comb should move easily through all the hair. Make sure all hair is smooth and entirely free of even the smallest tangles.
2 Divide hair into small sections and use the fine-tooth comb to comb the sections to make sure that all the knots have been removed. Even small knots will cause problems down the road.
3 Select section of hair that you wish to braid. It can be on any part of the scalp and can be any amount of hair. If you're starting out, it might be easier to work with a smaller strand of hair because they'll be easier to control.
4 Divide the hair into three even sections. Separate the sections with your hands and make sure they don't mix together at any time.
5 Cross the left hand section over the middle section. The original left hand section is now the middle section.
6 Still keep the sections separately and tightening the plait by pulling all the sections away from each other.
7 Cross the right hand section over the middle section. The original right hand section is now the middle section.
8 Tighten the plait again.
9 Continue with this process alternating left and right sections over the middle section, tightening each plait as you make it.
10 Repeat until you run out of room, leave about an inch of unbraided hair at the end.
11 Secure the end of the braid with a hair-friendly ponytail holder.
1. We have the same thoughts, same answers.
4. You know your own duty, good job!
5. Do you dare to get inside alone?
Permalink Reply by Jija on August 13, 2009 at 10:43am
1. Hey you are reading my mind!
3. How to make a plait
1. comb your hair thoroughly
2. devide your hair in to 3 equal parts (Or part your hair into 3 bunch equally)
3. Cross left and right bunch of the hair over the middle bunch
4. tie it up with a rubber band